• Trigger - Input

• Synchronous Reference Output

• 6 Delayed Output Channels

• Delay resolution 1.25 ns

• Pulse width (Signal) from 10 ns to 5.2 ms

• Maximum Cycle time 42.9 s

• Outputs TTL- / CMOS compatible

• PCI card, software for Windows 95, 98, NT, 2000 and  XP

• Works with any bh photon counting card

• Overload protection of detectors in conjunction with bh HFAC-26 preamps

• Full operation of Hamamatsu H7422 modules

• High-voltage control for Hamamatsu R3809U MCP via FuG power supplies

• High current digital outputs for shutter and filter control

• +12V, +5V and -5V power supply for preamps and detectors

• PCI card, software for Windows 95, 98, NT, 2000 and  XP

• Works with any bh photon counting card

Stepper Motor Controller

• Low Noise Level

• Directly Supported by Photon Counter Software

• Simultaneous Operation of 2 Motors ( unipolar )

• Half Step or Full Step Mode, Phase Currents up to 1A

• PCI card, software for Windows 95, 98, NT, 2000 and  XP

• Works with SPC-xxx and PMS-400(A) photon counting cards
   

Galvano Controller

• Waveform generator for X and Y galvano mirrors

• Differential output voltage X+/X- , Y+/Y-

• Maximum output range +/- 10V

• Scan signal generation for SPC-830, SPC-140, or SPC-150

• Laser control for all BDL lasers from bh

• PCI card, software for Windows 95, 98, NT, 2000 and  XP
   

USB-Controlled Delay Switch Box

• 32 step passive delay line

• Delay from 0 to 31.5 ns in 0.5 ns steps

• Transmits any signal waveform
• Signal Bandwidth 1 GHz
• No noise, no jitter
• No external power supply needed
• Settings persist when box is disconnected from USB
• Easy adjustment of TCSPC SYNC path length
• Control integrated in bh ‘SPCM’ TCSPC operating software